Miniature Checkers

This game board was inspired by a very cute backgammon board I found among my old dollhouse furniture from the seventies. It looks like it took a lot more time than it actually did and you can't tell that most of it is made from cardboard so it is a very rewarding project.

I used white cardboard. I stenciled a 2 inch square onto it but did not cut it out right away.

I drew 7 equal lines down each side to make the checker pattern, and colored in alternate squares using a black permanent marker. I tried to use regular marker pen and colored pencil but the cardboard has a bit of a shine to it and only the permanent marker worked. After I filled in the squares I cut out the board using a razor blade.

To make the game pieces I took black and red fimo (or sculpey) clay and rolled out two tiny tubes. The tubes should be smaller in diameter than your finished game piece will be. I used a razor blade to cut 12 pieces in each color. I cut pieces that were thicker than the ideal game piece, then flattened each one with my finger on a piece of tinfoil. I have had some bad experiences laboring long and hard on a Fimo project and then burning it to a crisp in the oven. These pieces are so incredibly tiny I just put them in the toaster oven, tinfoil on top of a tray, at 225 degrees for 8 minutes.

Next I took a strip of balsa trim that I bought at a craft store. It is 1/4 inch wide. Balsa wood is excellent because you can cut it fairly easily with a razor blade or exacto knife. I cut 2 pieces 2 inches long and glued them to opposite sides of the board. Then I lay the trim across the 3rd and 4th sides and marked with a a pencil where the cut should go. I used the razor blade to cut an angle where the two sides meet.
To finish up I glued a square of green felt to the bottom to hide the bottom.

Finally, I glued the pieces to the board. A more realistic checker board would have some loose pieces on the side that have been captured. I don't think my children will be able to keep track of tiny loose microscopic checkers so I glued everything down.

A Proper Bed for a Princess

Making a "proper" bed for a true princess, can only mean one thing.

You will need one pea and lots and lots of mattresses.

We made our Princess and the Pea bed from popsicle sticks and fabric scraps.

(coffee stirrers, toothpicks and tongue depressors too.)

1. Build a simple base for the bed. Cut one popsicle stick in half,

so you have 2 equal pieces. Glue across the sticks.

2.Then add the full size sticks. We used 5 for ours.

3.Next, make your 4 bed posts by simply gluing 2 sticks together

for each post.

4. If you like, you can decorate them. We wanted them a little

"fancier" so we drew on the sticks once they dried, and colored

with marker.

5. Then get ready to attach the base to the posts. This is the trickiest part,

and requires the most patience.

6. We definitely suggest, using any props, or tricks to help hold the pieces

in place while the glue dries.  Tape, clothespins, old cell phones, empty tins.

Be creative, use what works!

7. Now you have a great start but it's a bit wobbly. So add braces in

the weak spots. We used cut up pieces of tongue depressor around the

base. Then coffee stirrers on the sides.

8. Dont' forget the pea! You must have one. (we used a shiny

pea-green bead.)

9. Next, pick through your fabric scraps, and find around 15 or so scraps.

Cut them roughly, 6 x 5", fold them horizontally, wrong sides out. Sew along 2

sides, creating a sort of mini pillowcase. 1/2" seem.

10. Turn them all inside out, and then use a very small amount of fluff

to stuff, you want them more flat than puffy. Little hands are a great help at this!

When finished, turn the inside edges in, and sew across the edge (roughly 1/4" seem) to close up the mattress.

You can handsew the closing for a more finished look.

11. Stack those mattresses up.

The kids noticed we needed a ladder too.

Made from coffee stirrers and toothpicks.

12.Find a potential princess, and test it out!

Goodnight, sleep tight!

***If you enjoyed this post and like tiny things, check our latest post

And you can make a cute and tiny scout sash. like this one.